Chapter 21 WAN Commands

Table 63 wan backup Commands (continued)

COMMAND

DESCRIPTION

wan backup tolerance <0~9>

Sets the number of failed responses the ZyXEL

 

Device may receive when pinging the checkip IP

 

addresses before switching to a WAN backup

 

connection.

 

 

wan backup trafficredirect active

Activates or deactivates traffic redirection to a

<0:no1:yes>

backup gateway.

wan backup trafficredirect backIp

Sets the backup gateway’s IP address for traffic

<address>

redirection.

wan backup trafficredirect metric

Specifies the metric value for traffic redirection.

<number>

 

21.3.1 wan backup Examples

The following example:

•Loads the WAN backup configuration information.

•Specifies the following IP addresses to check: 192.168.1.100, 192.168.1.150, 192.168.1.175

•Sets the ZyXEL Device to periodically ping the IP addresses.

•Sets the timeout in seconds for an ICMP ping to 5.

•Sets the tolerance to 5.

•Sets the recovery interval to 60.

•Activates dial backup.

•Sets the AT command used to answer a call to "A0".

•Sets the number of seconds the ZyXEL Device tries to make a call before timing out to 20.

•Sets the number of times the ZyXEL Device tries a busy or no-answer phone number before blacklisting it to 10.

•Sets the dial backup port speed to 9600.

•Saves the current setting in the WAN backup working buffer to the permanent memory.

158

 

DSL & IAD CLI Reference Guide