|
| Chapter 21 WAN Commands |
| Table 66 wan node Commands (continued) |
|
| COMMAND | DESCRIPTION |
| wan node routeip <onoff> | Activates or deactivates IP routing on the |
|
| |
| wan node save | Saves configured information about the WAN node |
|
| you previously specified with the wan node index |
|
| <node#> command to the permanent memory. |
|
| Note: Changes to the configuration in the |
|
| working buffer are not saved or |
|
| used until you enter this command. |
|
|
|
| wan node scr <scr> | Sets the Sustainable Cell Rate (SCR) of the |
|
| |
| wan node service <name> | Sets the PPPoE service name of the previously- |
|
| specified WAN node profile. |
| wan node vci <vci> | Sets the VCI (Virtual Channel Identifier) of the |
|
| |
| wan node vpi <vpi> | Sets the VPI (Virtual Path Identifier) of the |
|
| |
| wan node wanip <<static> | Sets the WAN IP address of the |
| <ip>><dynamic> | WAN node profile. |
21.6.1 wan node Examples
The following example:
•Sets the active node profile to node 1 (the ISP node profile).
•Sets the profile name to "ISP1".
•Sets the multicast mode to IGMP version 2.
•Sets the NAT mode to SUA only.
•Sets the PPP authentication method to CHAP.
•Sets the PPP username to "User1".
•Sets the PPP password to "Pass1".
•Sets the PPP idle timeout to 240 seconds.
•Sets the remote gateway IP address to 192.168.1.254, with a subnet mask of 255.255.255.0.
•Activates IP routing.
•Sets the service name to "ISPservice".
•Sets the VPI to 30 and the VCI to 33.
•Sets the WAN IP address to be dynamic.
•Saves the settings.
•Sets the active node profile to node 2 again.
| 167 |
DSL & IAD CLI Reference Guide | |
|
|