Chapter 21 WAN Commands
Table 63 wan backup Commands (continued)
COMMAND |
|
| DESCRIPTION |
wan backup | dialbackup | ATresponse | Specifies the keyword preceding the dialed number. |
callid |
|
| |
wan backup | dialbackup | ATresponse | Sets the keyword preceding the Calling Line |
clid <clid> |
|
| Identification in the AT response |
wan backup | dialbackup | ATresponse | Specifies the keyword preceding the connection |
speed <speed> |
| speed. | |
wan backup | dialbackup | callctl | Sets the number of seconds the ZyXEL Device |
callbackdelay <seconds> | waits between dropping a callback request call and | ||
|
|
| dialing the corresponding callback call. |
wan backup | dialbackup | callctl | Sets the number of seconds the ZyXEL Device tries |
dialtimeout <seconds> |
| to make a call before timing out. | |
wan backup | dialbackup | callctl | Sets the number of seconds the ZyXEL Device |
droptimeout <seconds> |
| waits before dropping the DTR signal if it does not | |
|
|
| receive a positive disconnect confirmation. |
wan backup | dialbackup | callctl | Sets the number of times the ZyXEL Device tries a |
retrycount | <metric> |
| busy or |
|
|
| blacklisting it. |
wan backup | dialbackup | callctl | Sets the number of seconds the ZyXEL Device |
retryinterval <seconds> | waits before calling a busy or unanswered number | ||
|
|
| again. |
wan backup | dialbackup | dropDTR | Activates or deactivates the dropping of the Data |
<0:no1:yes> |
| Terminal Ready (DTR) signal after the wan backup | |
|
|
| dialbackup ATcommand drop <command> |
|
|
| string is issued. |
wan backup dialbackup init <command> | Sets the AT command used to initialize the WAN | ||
|
|
| device connected to the dial backup port. |
wan backup | dialbackup | portspeed | Sets the speed of the connection between the dial |
<1:96002:192003:384004:576005:1 | backup port and the external device. | ||
152006:230400> |
|
| |
wan backup | display |
| Shows the WAN backup information currently |
|
|
| stored in the memory buffer. |
wan backup | free |
| Clears the WAN backup information in the working |
|
|
| buffer. |
| Note: Use this command before working |
| on another WAN backup profile. |
|
|
wan backup icmptimeout <seconds> | Sets the timeout in seconds for an ICMP ping. |
wan backup load | Loads the WAN backup configuration into the |
| working buffer. |
wan backup recovery <seconds> | Sets the number of seconds the ZyXEL Device |
| waits, when using a WAN backup connection, |
| before trying to reconnect using the higher priority |
| connection. |
|
|
wan backup save | Saves the current setting in the WAN backup |
| working buffer to the permanent memory. |
| Note: Changes to the configuration in the |
| working buffer are not saved or |
| used until you enter this command. |
| 157 |
DSL & IAD CLI Reference Guide | |
|
|