Chapter 19 System Commands

Table 44 sys Commands (continued)

 

 

COMMAND

DESCRIPTION

 

sys filter set protocol

Sets the rule to match a specified protocol. 0 sets the rule to match

 

[protocol#]

any protocol.

 

 

TCP/IP rules only.

 

sys filter set save

Saves the set’s configuration.

 

sys filter set sourceroute

Enables or disables the filtering of packets based on whether their

 

[yesno]

sourceroute option is enabled or not.

 

 

TCP/IP rules only.

 

sys filter set srcip [source-

Sets the source IP address and subnet mask of the set.

 

ip][mask]

TCP/IP rules only.

 

sys filter set srcport [source-

Sets the source port and compare type.

 

port][compare-type]

TCP/IP rules only.

 

sys filter set tcpestab [yesno]

yes sets the rule to match packets that request a TCP/IP connection.

 

 

no sets the rule to ignore this behavior.

 

 

TCP/IP rules only.

 

 

 

 

sys filter set type

Sets the type of filter rule.

 

[tcpipgeneric]

tcpip: Choose TCP/IP filtering to filter packets based on source and

 

 

destination IP address, destination port and protocol.

 

 

generic: Choose generic filtering to filter packets based on bit

 

 

pattern matching.

 

sys filter set value [value]

Sets the value of the data to be compared with the packet data

 

 

delimited by the offset and length values.

 

 

value: Enter this three byte value in hexadecimal notation, e.g.,

 

 

F:F:F.

 

 

Generic rules only.

 

 

 

 

sys filter sw

Turns on or off the filtering counter switch.

 

sys firewall

See Chapter 12 on page 67 for details on the these commands.

 

sys general bridge <onoff>

Enables or disables system bridging.

 

sys general contactname

Sets the contact person’s name.

 

[contact-name]

 

 

sys general display

Displays general system configuration information, including

 

 

hostname. domain name. location, contact details and system mode.

 

sys general domainname [domain-

Sets the domain name.

 

name]

 

 

sys general hostname [host-name]

Sets the system name.

 

sys general load

Loads general system information into the buffer.

 

sys general location [location]

Sets the geographical location of your device.

 

sys general routip <onoff>

Enables or disables system routing.

 

sys general save

Saves general information to non-volatile memory.

 

sys hostname [hostname]

Sets or displays the system hostname.

 

sys logs category 8021.x

Activates or deactivate logging for IEEE 802.1X authentication

 

[0:none1:log]

requests.

 

sys logs category access

Setswhethera logand/oranalertismadeforrequestsforaccess.

 

[0:none1:log2:alert3:both]

 

 

sys logs category anyip

Enables or disables recording of AnyIP logs and/or sending an alert.

 

[0:none1:log]

 

 

 

121

DSL & IAD CLI Reference Guide