
Chapter 21 WAN Commands
• Saves the current configuration.
ras> wan atm vchunt active yes ras> wan atm vchunt add 2 30 33 63 ras> wan atm vchunt display
(1)Configure Buffer Flags: Active
RN VPI VCI service
1 30 33 63H
(2)RemoteNode (Read Only)
RN VPI VCI RN VPI VCI RN VPI VCI RN VPI VCI
1 | 8 | 35 2 | 0 | 0 | 3 | 0 | 0 | 4 | 0 | 0 | |
5 | 0 | 0 | 6 | 0 | 0 | 7 | 0 | 0 | 8 | 0 | 0 |
9 | 0 | 0 |
|
|
|
|
|
|
|
|
|
(3)VC Hunt Table: (User setting) Flags: Active(1)
RN VPI | VCI | serv RN VPI |
| VCI serv RN VPI |
| VCI serv RN VPI | VCI serv | ||||||||
32 | 3fH | ||||||||||||||
1 | 0 | 33 | 3fH | 1 | 0 | 35 | 3fH | 1 | 1 | 35 | 3fH | 1 | 8 | ||
1 | 0 | 101 | 3fH | 1 | 0 | 50 | 3fH | 1 | 0 | 32 | 3fH | 1 | 14 | 24 | 3fH |
1 | 0 | 38 | 4H | 0 | 0 | 0 | 0H |
|
|
|
|
|
|
|
|
(4)WebRedirect: Enable ras> wan atm vchunt save ras>
21.3wan backup Commands
Use these commands to configure the ZyXEL Device’s WAN backup settings.
Table 63 wan backup Commands
COMMAND | DESCRIPTION |
wan backup 1checkip | Specifies the first IP address to check for |
| connectivity (when icmp checking is activated). |
wan backup 2checkip | Specifies the second IP address to check for |
| connectivity (when icmp checking is activated). |
wan backup 3checkip | Specifies the third IP address to check for |
| connectivity (when icmp checking is activated). |
wan backup checkmech <icmpdsllink> | Specifies the method the ZyXEL Device uses to |
| check the DSL connection. |
| icmp: periodically ping the checkip IP addresses. |
| dsllink: check the connection to the DSLAM. |
wan backup dialbackup active | Activates or deactivates dial up backup. |
<0:off1:on> |
|
wan backup dialbackup ATcommand | Sets the AT command used to answer a call. |
answer <command> |
|
wan backup dialbackup ATcommand dial | Sets the AT command used to make a call. |
<command> |
|
wan backup dialbackup ATcommand drop | Sets the AT command used to end a call. |
<command> |
|
156 |
| |
DSL & IAD CLI Reference Guide |
| |
|
|
|