Chapter 21 WAN Commands

Table 66 wan node Commands (continued)

COMMAND

DESCRIPTION

wan node backup pppopt com <yesno>

Activates or deactivates PPP compression on the

 

previously-specified WAN backup node.

wan node backup pppopt encap

Sets the PPP encapsulation mode of the previously-

<stdcisco>

specified WAN backup node.

 

std: standard PPP encapsulation.

 

cisco: Cisco PPP encapsulation.

wan node backup priph <primary-

Specifies the phone number the ZyXEL Device

phone#>

should call in order to make a connection to the

 

previously-specified backup WAN node.

wan node backup private <yesno>

Specifies whether the previously-specified WAN

 

backup node is private or not.

wan node backup remoteip <ip-

Sets the remote gateway IP address and subnet

address> <subnet mask>

mask of the previously-specified WAN backup node.

wan node backup rip

Sets the Routing Information Protocol (RIP) mode

<noneinoutboth>

and type of the previously-specified WAN backup

 

node.

wan node backup script set <1~6>

Configures the specified PPP chat script to transmit

<expect> <send>

the defined send string when it receives the defined

 

expect string.

 

For example, the command:

 

wan node backup set 2 123 456

 

sets script 2 to transmit “456” when it receives

 

“123”.

 

Note: Use the wan node index 9

 

command to specify the backup

 

WAN node.

 

 

wan node backup secph <secondary-

Specifies the backup phone number the ZyXEL

phone#>

Device should call in order to make a connection to

 

the previously-specified backup WAN node.

 

The ZyXEL Device calls this number if the primary

 

phone number is busy or does not answer.

 

 

wan node backup wanip <static <ip-

Sets the WAN IP address and mode (static or

address>dynamic>

dynamic) of the previously-specified WAN backup

 

node.

wan node bridge <onoff>

Activates or deactivates bridge mode on the

 

previously-specified WAN node profile.

wan node bridgetimeout <minutes>

Type the time (in minutes) for the ZyXEL Device to

 

retain the Ethernet address information in its internal

 

tables while the line is down. If this information is

 

retained, your ZyXEL Device will not have to

 

recompile the tables when the line comes back up.

 

 

wan node callsch <set#1> <set#2>

Sets the call scheduling profile(s) used by the

<set#3> <set#4>

previously-specified WAN node profile.

 

Use the wan callsch commands to configure call

 

scheduling profiles.

wan node clear

Returns the WAN node you previously specified

 

with the wan node index <node#> command to

 

its defaults.

wan node disable

Deactivates the previously-specified WAN node

 

profile.

164

 

DSL & IAD CLI Reference Guide