Chapter 22 Wireless LAN Commands
Table 69 General Wireless Commands (continued)
COMMAND | DESCRIPTION |
wlan dbg <level> | Sets the WLAN debug settings. |
| For example, enter 0 to turn debugging off. |
| Enter 1 to turn DEBUG INIT on. |
| Enter 2 to turn DEBUG Tx on. |
| Enter 4 to turn DEBUG Rx on. |
| level: RA_DEBUG_OFF[0] |
| RA_DEBUG_INIT[1] |
| RA_DEBUG_TX[2] |
| RA_DEBUG_RX[4] |
| RA_DEBUG_TX_DATA[8] |
| RA_DEBUG_RX_DATA[10] |
| RA_DEBUG_ERR[20] |
| RA_DEBUG_CMD[40] |
| RA_DEBUG_TASK[80] |
| RA_DEBUG_INFO[100] |
| RA_DEBUG_IOCTL[200] |
| RA_DEBUG_WSC[400] |
| RA_DEBUG_ALL[fff] |
|
|
wlan display | Displays the WLAN configuration currently in the |
| working buffer. |
wlan essid <essid> | Sets the wireless AP’s SSID. |
wlan filter <incomingoutgoing> | Specifies the filter action, type and profile to be used |
<tcpipgeneric> <profile> | by the WLAN. |
| incoming: the filter applies to traffic coming from |
| the WAN to the LAN. |
| outgoing: the filter applies to traffic coming from |
| the LAN to the WAN. |
| tcpip: the filter checks IP addresses. |
| generic: the filter checks MAC addresses. |
| profile: filter profile number 1~4. Use the sys |
| filter set commands to configure filter profiles. |
wlan fraThreshold <256~2346> | Sets the fragmentation threshold. If the packet size |
| is over this value, it is fragmented. |
wlan getaplist | Scans for and displays information of other APs |
| within transmission range. |
wlan getchannel | Chooses a channel with least interference. |
wlan getcounter | Displays wirelsss statistics. |
wlan hideessid <onoff> | Sets whether the SSID is hidden (not broadcast). |
| on: SSID is hidden. |
| off: SSID is not hidden. |
wlan ht bw <01> | Sets the channel width used by the ZyXEL Device. |
| 0: Channel Width = 20 MHz |
| 1: Channel Width = 20/40 MHz |
|
|
wlan ht gi <01> | Sets the IEEE 802.11n HT (high throughput) guard |
| interval. |
| 0: 800 ns long guard interval |
| 1: 400 ns short guard interval |
|
|
178 |
| |
DSL & IAD CLI Reference Guide |
| |
|
|
|