Chapter 21 WAN Commands

Table 66 wan node Commands (continued)

COMMAND

DESCRIPTION

wan node multicast

Sets the multicast mode of the previously-specified

<noneigmpv1igmpv2>

WAN node profile.

wan node mux <vcllc>

Sets the multiplexing protocol used by the

 

previously-specified WAN node profile.

 

<vc>: virtual circuit-based

 

<llc>: logical link control-based

wan node nailedup <onoff>

Activates or deactivates a nailed-up (always on)

 

connection for the previously-specified WAN node

 

profile.

 

 

wan node nat <nonesua<full

Sets the Network Address Translation (NAT)

<rule#>>

method of the previously-specified WAN node

 

profile.

 

<off>: NAT is not active

 

<sua>: Use Single User Account only (if you have

 

just one public WAN IP address for your ZyXEL

 

Device).

 

<full> : Use full-feature NAT (if you have multiple

 

public WAN IP addresses for your ZyXEL Device).

 

<rule#> : When you choose full-feature NAT,

 

specify the address mapping rule to apply. Use the

 

ip nat addrmap rule command to configure

 

address mapping rules.

wan node pcr <pcr>

Sets the Peak Cell Rate (PCR) of the previously-

 

specified WAN node profile.

wan node ppp authen <papchapboth>

Sets the PPP authentication method for the

 

previously-specified WAN node profile.

wan node ppp idletime <seconds>

Sets the PPP idle timeout.

wan node ppp password <password>

Sets the PPP password for the previously-specified

 

WAN node profile

wan node ppp username <username>

Sets the PPP user name for the previously-specified

 

WAN node profile

wan node private <yesno>

Specifies whether the previously-specified WAN

 

node is private or not.

 

This command determines whether or not the

 

ZyXEL Device includes the route to this remote

 

node in its RIP broadcasts. If you select yes, this

 

route is not included in RIP broadcast. If you select

 

no, the route to this remote node is propagated to

 

other hosts through RIP broadcasts.

wan node qos

Sets the QoS (Quality of Service) type used by the

<ubrcbrvbr_nrtvbr_rt>

previously-specified WAN node profile.

 

<ubr>: Unspecified Bit Rate

 

<cbr>: Constant Bit Rate

 

<vbr_nrt>: Variable Bit Rate (Non-Real-Time)

 

<vbr_rt>: Variable Bit Rate (Real-Time)

wan node remoteip <ip-address>

Sets the remote gateway IP address of the

<subnet>

previously-specified WAN node profile.

wan node rip <noneinoutboth>

Sets the Routing Information Protocol (RIP) mode

<rip1rip2brip2m>

and type of the previously-specified WAN node

 

profile.

166

 

DSL & IAD CLI Reference Guide