Chapter 19 System Commands
Table 44 sys Commands (continued)
COMMAND | DESCRIPTION |
sys view <filename> | Displays the specified text file. |
sys wdog cnt [value] | Sets or displays the current watchdog count. This value represents |
| the time interval at which the system is checked for normal operation. |
| If watchdog detects a system crash the system is restarted. |
| Use sys wdog switch to activate watchdog before configuring. |
| value: This is a value from |
sys wdog switch [onoff] | Turns the watchdog firmware protection feature on or off. |
sys xmodemmode [crcchecksum] | Changes the console port xmodem mode. |
The following table shows a list of default values.
Table 45 sys Default Values
VARIABLE | DEFAULT VALUE |
sys ddns config active [01] | 0 |
sys filter netbios config | 0:Between LAN and WAN: Off/Forward |
<01234><onoff> | 3:IPSec passthrough: off/forward |
| 4:Trigger Dial: off/disable |
|
|
sys general routip <onoff> | on |
sys general bridge <onoff> | off |
sys logs syslog active [0:no1:yes] | 0 |
sys snmp trap community <community> | public |
sys stdio [minute] | 5 |
sys tos sessPerHost <session#> | 512 |
sys tos tempTOSTimeout [timeout] | 5 |
sys tos timeout gre <timeout> | 9000 |
sys tripleplay igmpsnp maxresptime | 100 |
[tenthsofasecond] |
|
sys tripleplay igmpsnp queryinterval | 125 |
[seconds] |
|
sys tripleplay igmpsnp robust | 2 |
[robustness] |
|
sys upnp active [0:no1:yes] | 0 |
sys wdog cnt [value] | 180 |
sys wdog switch [onoff] | on |
sys xmodemmode [crcchecksum] | crc |
19.2 Command Example
The following examples show you first how to configure logs and then how to display them.
128 |
| |
DSL & IAD CLI Reference Guide |
| |
|
|
|