Chapter 20 VoIP Commands
• displays the mapping to only phone port 1 for SIP 1 account.
ras> voice config signal | index 1 |
ras> voice config signal | phoneselect 1 2 0 |
ras> voice config signal | phoneselect 1 1 1 |
ras> voice config signal | save 1 |
ras> voice config signal | display 1 |
Mapping phone port: | 1 |
20.4 Analog Phone Commands
Use these commands to configure analog phone features on the ZyXEL Device.
Table 51 Analog Phone Command Summary
COMMAND | DESCRIPTION |
voice config fxs index <index> | Specifies the analog phone port for configuration. |
voice config fxs echocancellation <index> | Disables or enables echo cancellation. |
<enabledisable> |
|
voice config fxs jittersize <index> | Sets the jitter buffer size in miliseconds. |
voice config fxs vad <index> | Disables or enables the VAD (Voice Activity Detection). |
<enabledisable> |
|
voice config fxs dialshortinterval <index> | Sets the dialshortinterval value. |
<interval> | This is the time interval (in seconds) that the ZyXEL |
| Device waits between digits being dialed when making a |
| call. If time between dialed digits exceeds this value the |
| ZyXEL Device considers the dialing to be completed and |
| calls the number entered. |
| Enter a value between |
|
|
voice config fxs diallonginterval <index> | Sets the diallonginterval value. |
<interval> | This is the time interval (in seconds) that the ZyXEL |
| Device waits until the first digit is dialed when making a |
| call. If no digit is dialed in this time period the ZyXEL |
| Device sends a busy signal. |
| Enter a value between |
|
|
voice config fxs flashmaxinterval <index> | Sets the flash key maximum interval (in miliseconds). |
<interval> | If the flash key is pressed for a longer period, then it will |
| be ignored. Users must press the flash key for a period of |
| time smaller than the flash key maximum interval but |
| greater than the flash key minimum interval for it to be |
| recognized by the system. |
| Enter a value between 0~65535. |
|
|
voice config fxs flashmininterval <index> | Setup flash key minimum interval. |
<interval> | If the flash key is pressed for a shorter period, then it will |
| be ignored. Enter a value between 0~65535. |
voice config fxs inputvolume <index> | Sets the input volume level. |
<volume> | The level can be in the range |
voice config fxs outputvolume <index> | Sets the output volume level. |
<volume> | The level can be in the range |
voice config fxs sipselect <index> <phone- | Configures an analog phone to SIP account mapping |
port0:All> <0:no1:yes> | and enables the specified SIP account. |
| 137 |
DSL & IAD CLI Reference Guide | |
|
|