Chapter 14 IPSec Commands
Table 34 IPSec Commands (continued)
COMMAND |
| DESCRIPTION |
ipsec dial | Dials the specified IPSec policy manually. | |
ipsec display | Displays the specified IPSec rule. Use ipsec load to | |
|
| load an IPSec rule before using this command. |
ipsec load | Loads the specified IPSec rule for editing. | |
ipsec save |
| Saves the IPSec rule settings. |
ipsec config | netbios active <onoff> | Sets whether or not NetBIOS packets are allowed to pass |
|
| through VPN tunnels. |
ipsec config | name <name> | Sets the rule’s name (up to 32 characters). |
ipsec config | active <YesNo> | Turns the rule on or off. |
ipsec config | natTraversal <YesNo> | Turns NAT traversal on or off. |
ipsec config | keepAlive <YesNo> | Turns keep alive on or off. |
ipsec config | lcIdType <0:IP1:DNS | Sets the local ID type. |
2:Email> |
|
|
ipsec config | lcIdContent <content> | Sets the local ID content with the specified IP address, |
|
| domain name, or |
ipsec config | myIpAddr | Sets the local VPN gateway with the specified IP address. |
ipsec config | peerIdType | Sets the peer ID type. |
<0:IP1:DNS2:Email> |
| |
ipsec config | peerIdContent <content> | Sets the peer ID content with the specified IP address, |
|
| domain name, or |
ipsec config | secureGwAddr <ip- | Sets the remote gateway address with the specified IP |
address or domain name. | ||
ipsec config | protocol <1:ICMP | Sets the traffic protocol that can trigger the VPN tunnel |
6:TCP17:UDP> | and be forwarded through it. | |
ipsec config | lcAddrType | Sets the address type for the local network. |
<0:single1:range2:subnet> |
| |
ipsec config | lcAddrStart | Sets the local network starting IP address. |
ipsec config | lcAddrEndMask | Sets the local network ending IP address for a range or |
|
| the subnet mask for a subnet. |
ipsec config lcPortStart <port> | Sets the starting port for local network traffic. Only traffic | |
|
| using the specified ports can go through the VPN tunnel. |
ipsec config lcPortEnd <port> | Sets the ending port for local network traffic. | |
ipsec config dynamicLocal <OnOff> | Sets the local network IP address range to be dynamic | |
|
| (any). |
ipsec config rmAddrType | Sets the address type for the remote network. | |
<0:single1:range2:subnet> |
| |
ipsec config rmAddrStart | Sets the remote network starting IP address. | |
ipsec config | rmAddrEndMask | Sets the remote network ending IP address for a range or |
|
| the subnet mask for a subnet. |
ipsec config | rmPortStart <port> | Sets the starting port for remote network traffic. Only traffic |
|
| using the specified ports can go through the VPN tunnel. |
ipsec config | rmPortEnd <port> | Sets the ending port for remote network traffic. |
ipsec config | dynamicRemote <OnOff> | Sets the remote network IP address range to be dynamic |
|
| (any). |
90 |
| |
DSL & IAD CLI Reference Guide |
| |
|
|
|