Chapter 13 IP Commands

Table 30 IP Commands (continued)

COMMAND

DESCRIPTION

ip igmp iface <interface> ttl

Sets the IGMP Time To Live threshold.

<0-2147483647>

 

ip igmp iface <interface>

Turns IGMP version 1 compatibility on or off for the

v1compat [onoff]

specified interface.

ip igmp proxy [01]

Set 1 to send the IGMP leave message immediately while

 

set 0 to wait a time interval (260 seconds) before sending

 

the leave message.

 

 

ip igmp robustness [2-

Sets the IGMP robustness variable.

2147483647]

 

ip igmp status

Displays the IGMP status.

ip mcastChan

Displays or controls whether the ZyXEL Device sends the

[0:both1:LAN2:WLAN]

multicast packets to the LAN or WLAN or both.

ip ping <address>

Pings a remote host IP address or domain name.

ip policyrouting set index

Loads or allocates a working buffer to editing a policy route

<set-number><rule-number>

rule. You must apply this command first before you begin to

 

configure the IP policy route rules.

 

set-number:1-12

 

rule-number:1-6

 

 

ip policyrouting set name

Sets the name of IP policy route set.

<name>

 

 

 

ip policyrouting set active

Enables or disables the IP policy route rule.

<yesno>

 

ip policyrouting set criteria

Sets the IP policy route protocol ID.

protocol <0:don’t

 

care1:ICMP6:TCP17:UDP>

 

ip policyrouting set criteria

This sets the Type of Service (TOS) values to prioritize the

serviceType <0:don’t

incoming network traffic. The values include normal

care1:normal2:min delay3:

service, minimize delay, maximize throughput, maximize

max thruput4:max

reliability, or minimize cost.

reliable5:min cost>

 

ip policyrouting set criteria

Sets the IP policy route precedence.

precedence <0-78:don’t care>

 

ip policyrouting set criteria

Sets the IP policy route packet length.

packetlength <length>

 

ip policyrouting set criteria

Sets the IP policy route criteria for the specified packet

lencomp <1:equal2:not

length above.

equal3:less4:greater5:less

 

or equal6:greater or equal>

 

ip policyrouting set criteria

Sets the IP policy route source IP address

srcip <start-ip><end-ip>

 

ip policyrouting set criteria

Sets the IP policy route source ports.

srcport <start-port> <end-

 

port>

 

ip policyrouting set criteria

Sets the IP policy route destination IP addresses.

destip <start-ip><end-ip>

 

74

 

DSL & IAD CLI Reference Guide