Chapter 19 System Commands

Table 44 sys Commands (continued)

 

 

COMMAND

DESCRIPTION

 

sys logs mail logAddr [mail-

Sets or displays the e-mail address to send logs to.

 

address]

 

 

sys logs mail passwd [smtp-user-

Sets the SMTP authentication password.

 

password]

 

 

sys logs mail port [port]

Sets the port number for sending log e-mails.

 

sys logs mail schedule display

Displays the log email schedule, including day and time and whether

 

 

an immediate alert is required.

 

sys logs mail schedule hour <0-

Sets the hour to send the logs.

 

23>

 

 

sys logs mail schedule minute <0-

Sets the minute to send the logs.

 

59>

 

 

sys logs mail schedule policy

Sets how often the ZyXEL Device sends log e-mails.

 

<0:full1:hourly2:daily3:weekl

 

 

y4:none>

 

 

sys logs mail schedule week

Sets the day of the week to send the e-mail log.

 

<0:sun1:mon2:tue3:wed4:thu5

 

 

:fri6:sat>

 

 

sys logs mail sendmail

Immediately sends a log by e-mail.

 

sys logs mail server <domain-

Specifies the server name or the IP address of the mail server for the

 

nameip-address>

e-mail address specified as the mail sender.

 

sys logs mail subject <mail-

Specifies the title in the subject line of the diagnostic e-mail message

 

subject>

that the ZyXEL Device sends.

 

sys logs mail user [smtp-

Specifies (or displays) the user name (up to 31 characters) for the e-

 

username]

mail account the ZyXEL Device uses for e-mailing logs.

 

sys logs save

Saves the log settings to long term memory.

 

sys logs syslog active

Enables or disables the UNIX syslog.

 

[0:no1:yes]

 

 

sys logs syslog display

Displays the syslog settings, including status, syslog IP address and

 

 

log facility.

 

sys logs syslog facility [local-

Logs the messages to different files located on the syslog server.

 

id]

local-id: The number of files available depends on the syslog

 

 

utility used. For example, the Kiwilog supports seven files.

 

sys logs syslog server [domain-

This sets the domain name and IP address for the syslog server to

 

nameip-address]

send the logs.

 

sys password <new-password>

Sets the system administrator password.

 

sys pwderrtm [minute]

Sets or displays the password error blocking timeout value in

 

 

minutes. Not devices support this command.

 

sys qe acl add <ila> <ilp> <oga>

Adds an ACL rule in the QE (quick engine) ACL table.

 

<ogp> <proto> <direction>

ila: Enters the inside local address, that is the source or destination

 

 

address of packets on the LAN.

 

 

ilp: Enters the inside local port.

 

 

oga: Enters the outside global address, that is the source or

 

 

destination address of packets on the WAN.

 

 

ogp: Enters the outside global port.

 

 

proto: Specifies the protocol type. 1: TCP, 0: UDP

 

 

direction: Specifies the traveling direction of the packets. 1:

 

 

outgoing, 0: incoming

 

 

123

DSL & IAD CLI Reference Guide