ZyWALL 5/35/70 Series User’s Guide
Figure 53 Load Balancing: Spillover
The following table describes the related fields in this screen.
Table 35 Load Balancing: Spillover
LABEL | DESCRIPTION |
|
|
Active/Active | Select Active/Active Mode and set the related fields to enable load balancing on the |
Mode | ZyWALL. |
Load Balancing | Select a load balancing method to use from the |
Algorithm |
|
Time Frame | You can set the ZyWALL to get the measured bandwidth using the average |
| bandwidth in the specified time interval. |
| Enter the time interval between 10 and 600 seconds. |
|
|
Send traffic to | Specify the maximum allowable bandwidth on the primary WAN. Once this maximum |
secondary WAN | bandwidth is reached, the ZyWALL sends the new session traffic that exceeds this |
when primary | limit to the secondary WAN. The ZyWALL continues to send traffic of existing |
WAN bandwidth | session to the primary WAN. |
exceeds |
|
7.8 WAN Route
Click NETWORK, WAN to open the Route screen. Use this screen to configure route priority.
Chapter 7 WAN Screens | 136 |