ZyWALL 5/35/70 Series User’s Guide

 

Table 135 Edit IP Policy Route (continued)

 

 

 

 

LABEL

DESCRIPTION

 

 

 

 

Packet Length

Type a length of packet (in bytes). The operators in the Len Compare field apply to

 

 

incoming packets of this length.

 

Length

Choose from Equal, Not Equal, Less, Greater, Less or Equal or Greater or

 

Comparison

Equal.

 

Source

 

 

 

 

 

Interface

Use the check box to select LAN, DMZ, WAN_1, WAN_2 and/or WLAN.

 

 

 

 

Starting IP

Enter the source starting IP address.

 

Address

 

 

Ending IP

Enter the source ending IP address.

 

Address

 

 

Starting Port

Enter the source starting port number. This field is applicable only when you select

 

 

TCP or UDP in the IP Protocol field.

 

Ending Port

Enter the source ending port number. This field is applicable only when you select

 

 

TCP or UDP in the IP Protocol field.

 

Destination

 

 

 

 

 

Starting IP

Enter the destination starting IP address.

 

Address

 

 

Ending IP

Enter the destination ending IP address.

 

Address

 

 

Starting Port

Enter the destination starting port number. This field is applicable only when you

 

 

select TCP or UDP in the IP Protocol field.

 

Ending Port

Enter the destination ending port number. This field is applicable only when you

 

 

select TCP or UDP in the IP Protocol field.

 

Action Applies to

Specifies whether action should be taken on criteria Matched or Not Matched.

 

 

 

 

Routing Action

 

 

 

 

 

Gateway

Select User-Definedand enter the IP address of the gateway if you want to specify

 

 

the IP address of the gateway. The gateway is an immediate neighbor of your

 

 

ZyWALL that will forward the packet to the destination. The gateway must be a

 

 

router on the same segment as your ZyWALL's LAN or WAN port.

 

 

Select WAN Interface to have the ZyWALL send traffic that matches the policy

 

 

route through a specific WAN port. Select the WAN port from the drop-down list

 

 

box.

 

 

Select the Use another interface when the specified WAN interface is not

 

 

available. check box to have the ZyWALL send traffic that matches the policy route

 

 

through the other WAN interface if it cannot send the traffic through the WAN

 

 

interface you selected. This option is only available when you select WAN

 

 

Interface.

 

Converted Type

Set the new TOS value of the outgoing packet. Prioritize incoming network traffic by

 

of Service

choosing Don’t Change, Normal, Min Delay, Max Thruput, Max Reliable or Min

 

 

Cost.

 

Converted

Set the new outgoing packet precedence value. Values are 0 to 7 or Don’t

 

Precedence

Change.

 

Log

Select Yes from the drop-down list box to make an entry in the system log when a

 

 

policy is executed.

 

Apply

Click Apply to save your changes back to the ZyWALL.

 

 

 

 

Cancel

Click Cancel to exit this screen without saving.

 

 

 

Chapter 24 Policy Route

396