ZyWALL 5/35/70 Series User’s Guide
Table 217 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set
FIELD | DESCRIPTION |
|
|
Server | This field is available only when you select Server in the Type field. |
Mapping |
|
Set |
|
Once you have finished configuring a rule in this menu, press [ENTER] at the message “Press ENTER to Confirm…” to save your configuration, or press [ESC] to cancel.
42.3 Configuring a Server behind NAT
Note: If you do not assign a Default Server IP address, the ZyWALL discards all packets received for ports that are not specified here or in the remote management setup.
Follow these steps to configure a server behind NAT:
1Enter 15 in the main menu to go to Menu 15 - NAT Setup.
2Enter 2 to open menu 15.2 (and configure the address mapping rules for the WAN port on a ZyWALL with a single WAN port).
Figure 320 Menu 15.2: NAT Server Sets
Menu 15.2 - NAT Server Sets
1.Server Set 1
2.Server Set 2
Enter Set Number to Edit:
3Enter 1 or 2 to go to Menu 15.2.x - NAT Server Setup and configure the address mapping rules for the WAN 1 or WAN 2 port on a ZyWALL with multiple WAN ports.
565 | Chapter 42 Network Address Translation (NAT) |