ZyWALL 5/35/70 Series User’s Guide
Table 192 Advanced WAN Port Setup: Call Control Parameters
FIELD | DESCRIPTION |
|
|
Call Control |
|
|
|
Dial Timeout (sec) | Enter a number of seconds for the ZyWALL to keep trying to set up an outgoing |
| call before timing out (stopping). The ZyWALL times out and stops if it cannot set |
| up an outgoing call within the timeout value. |
Retry Count | Enter a number of times for the ZyWALL to retry a busy or |
| number before blacklisting the number. |
Retry Interval (sec) | Enter a number of seconds for the ZyWALL to wait before trying another call after |
| a call has failed. This applies before a phone number is blacklisted. |
Drop Timeout (sec) | Enter a number of seconds for the ZyWALL to wait before dropping the DTR |
| signal if it does not receive a positive disconnect confirmation. |
Call Back Delay | Enter a number of seconds for the ZyWALL to wait between dropping a callback |
(sec) | request call and dialing the |
34.6 Remote Node Profile (Backup ISP)
On a ZyWALL with multiple WAN ports, enter 3 in Menu 11 - Remote Node Setup to open Menu 11.3 - Remote Node Profile (Backup ISP) (shown below) and configure the setup for your Dial Backup port connection.
On a ZyWALL with a single WAN port, enter 2 in Menu 11 - Remote Node Setup to open Menu 11.2 - Remote Node Profile (Backup ISP) and configure the setup for your Dial Backup port connection.
Chapter 34 WAN and Dial Backup Setup | 514 |