ZyWALL 5/35/70 Series User’s Guide

The following table describes the labels in this screen.

Table 15 VPN Wizard: Gateway Setting

LABEL

DESCRIPTION

 

 

Gateway Policy

 

Property

 

Name

Type up to 32 characters to identify this VPN gateway policy. You may use any

 

character, including spaces, but the ZyWALL drops trailing spaces.

My ZyWALL

When the ZyWALL is in router mode, enter the WAN IP address or the domain name

 

of your ZyWALL or leave the field set to 0.0.0.0.

 

For a ZyWALL with multiple WAN ports, the following applies if the My ZyWALL field

 

is configured as 0.0.0.0:

 

• When the WAN port operation mode is set to Active/Passive, the ZyWALL uses

 

the IP address (static or dynamic) of the WAN port that is in use.

 

• When the WAN port operation mode is set to Active/Active, the ZyWALL uses

 

the IP address (static or dynamic) of the primary (highest priority) WAN port to set

 

up the VPN tunnel as long as the corresponding WAN1 or WAN2 connection is

 

up. If the corresponding WAN1 or WAN2 connection goes down, the ZyWALL

 

uses the IP address of the other WAN port.

 

• If both WAN connections go down, the ZyWALL uses the dial backup IP address

 

for the VPN tunnel when using dial backup or the LAN IP address when using

 

traffic redirect. See the chapter on WAN for details on dial backup and traffic

 

redirect.

 

A ZyWALL with a single WAN port uses its current WAN IP address (static or

 

dynamic) in setting up the VPN tunnel if you leave this field as 0.0.0.0. If the WAN

 

connection goes down, the ZyWALL uses the dial backup IP address for the VPN

 

tunnel when using dial backup or the LAN IP address when using traffic redirect.

 

The VPN tunnel has to be rebuilt if this IP address changes.

 

When the ZyWALL is in bridge mode, this field is read-only and displays the

 

ZyWALL’s IP address.

Remote

Enter the WAN IP address or domain name of the remote IPSec router (secure

Gateway

gateway) in the field below to identify the remote IPSec router by its IP address or a

Address

domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN

 

IP address.

Next

Click Next to continue.

 

 

3.4 VPN Wizard Network Setting

Two active SAs cannot have the local and remote IP address(es) both the same. Two active SAs can have the same local or remote IP address, but not both. You can configure multiple SAs between the same local and remote IP addresses, as long as only one is active at any time.

Chapter 3 Wizard Setup

90