ZyWALL 5/35/70 Series User’s Guide

2.3.1 Procedure To Use The Reset Button

Make sure the SYS LED is on (not blinking) before you begin this procedure.

1Press the RESET button for ten seconds, and then release it. If the SYS LED begins to blink, the defaults have been restored and the ZyWALL restarts. Otherwise, go to step 2.

2Turn the ZyWALL off.

3While pressing the RESET button, turn the ZyWALL on.

4Continue to hold the RESET button. The SYS LED will begin to blink and flicker very quickly after about 20 seconds. This indicates that the defaults have been restored and the ZyWALL is now restarting.

5Release the RESET button and wait for the ZyWALL to finish restarting.

2.3.2Uploading a Configuration File Via Console Port

1Download the default configuration file from the ZyXEL FTP site, unzip it and save it in a folder.

2Turn off the ZyWALL, begin a terminal emulation software session and turn on the ZyWALL again. When you see the message "Press Any key to enter Debug Mode within 3 seconds", press any key to enter debug mode.

3Enter "y" at the prompt below to go into debug mode.

4Enter "atlc" after "Enter Debug Mode" message.

5Wait for "Starting XMODEM upload" message before activating Xmodem upload on your terminal. This is an example Xmodem configuration upload using HyperTerminal.

Figure 8 Example Xmodem Upload

Type the configuration file’s location,

or click Browse to search for it.

Choose the Xmodem protocol.

Then click Send.

6After successful firmware upload, enter "atgo" to restart the router.

2.4Navigating the ZyWALL Web Configurator

The following summarizes how to navigate the web configurator from the HOME screen. This guide uses the ZyWALL 70 screenshots as an example. The screens may vary slightly for different ZyWALL models.

Chapter 2 Introducing the Web Configurator

64