ZyWALL 5/35/70 Series User’s Guide
To edit the advanced setup for the Dial Backup port, move the cursor to the Edit Advanced Setup field in Menu 2 - WAN Setup, press the [SPACE BAR] to select Yes and then press [ENTER].
Figure 275 Menu 2.1: Advanced WAN Setup
Menu 2.1 - | Advanced WAN Setup |
|
AT Command | Strings: | Call Control: |
Dial= atdt | Dial Timeout(sec)= 60 | |
Drop= ~~+++~~ath | Retry Count= 0 | |
Answer= ata | Retry Interval(sec)= N/A | |
Drop DTR When Hang Up= Yes | Drop Timeout(sec)= 20 | |
Call Back Delay(sec)= 15 | ||
AT Response Strings: |
| |
CLID= NMBR = |
| |
Called | Id= |
|
Speed= | CONNECT |
|
Press ENTER to Confirm or ESC to Cancel:
The following table describes fields in this menu.
Table 191 Advanced WAN Port Setup: AT Commands Fields
FIELD | DESCRIPTION |
|
|
AT Command |
|
Strings: |
|
Dial | Enter the AT Command string to make a call. |
|
|
Drop | Enter the AT Command string to drop a call. “~” represents a one second wait, |
| e.g., “~~~+++~~ath” can be used if your modem has a slow response time. |
Answer | Enter the AT Command string to answer a call. |
|
|
Drop DTR When | Press the [SPACE BAR] to choose either Yes or No. When Yes is selected (the |
Hang Up | default), the DTR (Data Terminal Ready) signal is dropped after the “AT |
| Command String: Drop” is sent out. |
AT Response |
|
Strings: |
|
CLID (Calling Line | Enter the keyword that precedes the CLID (Calling Line Identification) in the AT |
Identification) | response string. This lets the ZyWALL capture the CLID in the AT response |
| string that comes from the WAN device. CLID is required for CLID |
| authentication. |
Called Id | Enter the keyword preceding the dialed number. |
|
|
Speed | Enter the keyword preceding the connection speed. |
|
|
513 | Chapter 34 WAN and Dial Backup Setup |