HPIIISi TWINAX CARD
3. Quick Start
CAUTION
The HPIIISi Twinax Card is
Take these steps to get your HPIIISi Twinax Card up and running quickly:
1.Power on the printer and perform a
2.Remove the power cord and other cables attached to the printer.
3.If you’re installing the Card in an HP LaserJet III series printer, remove the existing serial/ parallel card (or any other MIO card in the printer) by loosening the screws at either end of its bracket.
If you’re installing the Card into an HP LaserJet 4 series laser printer, remove the cover over the MIO expansion slot by loosening the screws at either end of its bracket.
NOTE
The Card can be installed in the upper MIO slot on the HP LaserJet 4Si and 4 SiMX with an optional bracket. The Card is shipped configured to fit into the lower MIO slot. If you need to install the Card into the upper MIO slot, call your supplier.
4.Remove the Card from the bag by its edges and align it with the connector inside the printer.
5.Place the bottom of the Card in the plastic card guide inside the printer and slide it into place.
6.Turn on the printer. After the printer is READY, perform an interface
First, take the printer offline, then use the “Menu” button to scroll through the HP menus until you reach the MIO menu associated with the Twinax Card. Press “Item” to display the Card’s Test Menu.
Press “+” to display the
10