
CHAPTER 14: TROUBLESHOOTING
Table 14-2. Troubleshooting Checklist (Continued)
Problem | Possible Causes | Recommended | |
Action | |||
|
| ||
|
|
| |
A port on a | The port is either off or | Enable the port via local or remote | |
MIM | segmented. | management. | |
managed by |
|
| |
the | Port cable is | Try connecting the port with a | |
cannot | defective. | different cable. | |
access the |
|
| |
network, |
|
| |
while other |
|
| |
ports on the |
|
| |
same MIM |
|
| |
are able to |
|
| |
access. |
|
| |
|
|
| |
User | Switch 7 has been | See Chapter 3 for information on | |
parameters | toggled and user- | the NVRAM switch setting. | |
(IP address, | entered parameters |
| |
Device and | have been reset to |
| |
Module | factory default. | If NVRAM is defective, call | |
name, etc.) |
| Cabletron Technical Support. | |
are lost | NVRAM may be |
| |
when device | defective. |
| |
is powered |
|
| |
down. |
|
| |
|
|
| |
No power to | EPIM is defective. | Replace EPIM. | |
an external |
|
| |
transceiver | AUI cable is defective. | Replace AUI cable. | |
connected to |
|
| |
an |
|
| |
|
|
| |
High number | External transceiver | Disable SQE. | |
of collisions | has SQE enabled. |
| |
on EPIM port. |
|
| |
|
|
| |
Port(s) go | Configurations where | Discuss these configurations with | |
into standby | devices connected | Cabletron Technical Support | |
for no | across | before implementing them into | |
apparent | channels can cause | your network. | |
reason. | the |
| |
| a looped condition. |
| |
|
|
|
|
|