CHAPTER 3: INSTALLATION

3.9CONNECTING TO THE NETWORK

This section gives procedures for connecting the EMM-E6 to the network using the various EPIMs available. When the EMM-E6 is first powered up, the EPIM 1 port acts as the bridge port and the EPIM 2 port is OFF.

Once you have successfully powered up your EMM-E6, you can add network connections. The procedure for connecting Ethernet segments to a hub varies depending on the media and ports you connect. Refer to the following list and perform the procedure described in the subsection(s) that apply to your hub:

EPIM-T

3.9.1

EPIM-X

3.9.2

EPIM-F1,F2,F3

3.9.3

EPIM-C

3.9.4

EPIM-A

3.9.5

3-18

EMM-E6 User’s Guide

Page 79
Image 79
Cabletron Systems EMM-E6 Ethernet manual Connecting to the Network