Canon DZ3600u manual Adjusting the Color Balance of Preview Images, Preview Mode

Adjusting the Color Balance of Preview Images

Preview

Mode

The color balance is normally adjusted automatically to the document or object with the auto white balance function. The following procedures may be used to adjust the color balance manually if the color equilibrium is disturbed by a marked change in the ambient lighting.

A large change in the ambient lighting around the DZ-3600U may throw off the color balance and produce a red or blue bias. In this case, you should reset the white balance with the following procedures. They can also be used to intentionally produce a red or blue tint.

1.Place the White Balance Adjustment Chart contained in the Quick Reference Guide onto the object stage as shown in the diagram.

2.Zoom the chart until it completely fills the window.

3.Press the [Auto] button in the white balance section of the control panel.

The auto indicator will flash until the white balance is reset, then it will turn off.

Replace the White Balance Adjustment Chart with your presentation materials and proceed with your presentation with the equipment in this state. If you wish to intentionally create a red or blue tint, press the [Manual] button after the steps above and use the manual dial to adjust the color.

To reactivate the auto white balance function, press the [Auto] button again.

••• Note •••

•The color balance can also be adjusted in still mode. However, the change in color cannot be verified unless a video monitor is directly connected to the DZ-3600U.

70