Cisco Systems 12000 series manual Examples, CF-779

show parser dump

redirection to a file using the redirect URL syntax at the end of the command is highly recommended. (See the documentation for the show <command> redirect command for more information on using this command extension.)

Output for this command will show the syntax options for all commands available in the specified mode. The preceding number shows the privilege level associated with that command. For example, the line

15 type dhcp

indicates that the type dhcp command has a privilege level of 15 assigned to it. For information about privilege levels, see the “Configuring Passwords and Privileges” chapter in the Cisco IOS Security Configuration Guide.

Any given command-line string should indicate the full syntax needed to make the command complete and valid. In other words, the command line string ends where the carriage return (Enter) could be entered, as indicated in command-line help by the <cr> syntax. You will typically see multiple forms of a command, each showing a valid syntax combination. For example, each of the following syntax combinations, as seen in the output of the show parser dump rtr include dhcp command, are valid commands:

type dhcp dest-ipaddr <address> source-ipaddr <address> option <82-82> circuit-id <string> type dhcp dest-ipaddr <address> source-ipaddr <address> option <82-82> remote-id <string> type dhcp dest-ipaddr <address> source-ipaddr <address> option <82-82> subnet-mask <ipmask>

type dhcp dest-ipaddr <address> source-ipaddr <address> option <82-82> type dhcp dest-ipaddr <address> source-ipaddr <address>

type dhcp dest-ipaddr <address> type dhcp

Use of the show command extensions begin, include, and exclude are recommended for this command, as these extensions allow you to filter the output to show only the commands you are interested in. The redirection extensions redirect, append, and tee allow you to redirect the output of this command to local or remote storage as a file.

As with most show commands, you can typically exit from the --More-- prompt back to EXEC mode using Ctrl-Z. For some connections, Ctrl-Shift-6 (Ctrl^) or Ctrl-Shift-6-X should be used instead.

Examples		The following example shows a typical list of command mode keywords:
		Router# show parser dump ?
		aaa-user	AAA user definition
		accept-dialin	VPDN group accept dialin configuration mode
		accept-dialout	VPDN group accept dialout configuration mode
		address-family	Address Family configuration mode
		aic	Alarm Interface Card configuration mode
		all	For all modes
		bba-group	BBA Group configuration mode
		bsm-cfg	BSM config definition
		cascustom	Cas custom configuration mode
		clid-group	CLID group configuration mode
		cns-connect-intf-config	CNS Connect Intf Info Mode
		config-l2tp-class	l2tp-class configuration mode
		config-rtr-http-rr	RTR HTTP raw request Configuration
		config-x25-huntgroup	X.25 hunt group configuration mode
		configure	Global configuration mode
		congestion	Frame Relay congestion configuration mode
		controller	Controller configuration mode
		dhcp	DHCP pool configuration mode
			Cisco IOS Configuration Fundamentals Command Reference
	July 2008			CF-779