Cisco Systems 12000 series manual Show platform, CF-793

show platform

show platform

To display platform information, use the show platform command privileged EXEC mode.

show platform {buffers copp rate-limit {arp dhcp atm-oam ethernet-oam pppoe-discovery all} np copp [ifnum] [detail] eeprom fault hardware capacity hardware pfc mode internal-vlan netint software ipv6-multicast connected tech-support ipmulticast group-ip-addrsrc-ip-addrtlb}

Syntax Description	buffers	Displays buffer-allocation information.
	copp rate-limit	Displays CoPP rate-limit information on the Cisco 7600 SIP-400.
	arp	Specifies ARP protocol packet traffic.
	dhcp	Specifies DHCP protocol packet traffic.
	atm-oam	Specifies ATM OAM packet traffic.
	ethernet-oam	Specifies Ethernet OAM packet traffic.
	pppoe-discovery	Specifies PPPoE discovery packet information.
	all	Displays rate-limit information for all protocols.
	np copp	Displays debug information for a given CoPP session ID or for all CoPP
		sessions.
	ifnum	Specifies a session ID.
	detail	Shows full rate-limited values.
	eeprom	Displays CPU EEPROM information.
	fault	Displays the fault date.
	hardware capacity	Displays the capacities and utilizations for hardware resources; see the
		show platform hardware capacity command.
	hardware pfc mode	Displays the type of installed PFC.
	internal-vlan	Displays the internal VLAN.
	netint	Displays the platform network-interrupt information.
	software ipv6-multicast	Displays all the IPv6 subnet ACL entries on the route processor; see the
	connected	show platform software ipv6-multicast command.
	tech-support ipmulticast	Displays IP multicast-related information for TAC.
	group-ip-addr	Group IP address.
	src-ip-addr	Source IP address.
	tlb	Displays information about the TLB register.
Defaults	This command has no default settings.
Command Modes	Privileged EXEC (#)

	Cisco IOS Configuration Fundamentals Command Reference
July 2008		CF-793