
Chapter 4 Installation and Maintenance
Removing and Replacing a Power Supply Unit
Reconnecting AC-Input Power Supply Unit
The following procedures explain how to reconnect an
If you are reconnecting
To reconnect the
Step 1 Plug the
Figure 4-14: Connecting the AC Power
Note For
15 A branch circuit protection is recommended.
Step 2 Plug the AC power supply cable into the AC power source. Step 3 Turn the on/off switch to the on (⏐) position.
Step 4 Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front panel. If the new
Step 5 Ensure that the power supply is properly aligned and the installation screw is tightened.
This completes the steps for reconnecting the
Reconnecting DC-Input Power Supply Unit
The following procedures explain how to reconnect a
Warning Before completing any of the following steps, and to prevent
Note that the power to the relevant power supply unit should be off, not necessarily all power to the SCE 2000 platform. One
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
| ||
|
|
|