Cisco Systems SCE 2000 4/8xFE manual To specify Primary, press Enter

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

Initial System Configuration

Enter Physically connected link: 0- link-0

1- link-1

Enter your choice [0]: Step 5 Specify the SCE 2000 priority.

•To specify Primary, press Enter.

•To specify Secondary, type 2 and press Enter.

Enter SCE 2000 priority: 1- primary

2- secondary

Enter your choice [1]:

Step 6 Specify the On-failure link behavior.

•To specify Bypass, press Enter.

•To specify Cutoff, type 2 and press Enter.

Enter On-failure behavior: 1- bypass

2- cutoff

Enter your choice [1]:

Step 7 Specify the status of the SCE 2000 after abnormal boot.

•To specify Operational status after abnormal boot, press Enter.

•To specify Not-Operationalstatus after abnormal boot, type 2 and press Enter.

Enter admin status of the SCE after abnormal boot: 1- Operational

2- Not-Operational Enter your choice [1]:

The following examples present the procedure for configuring the topology-related parameters for various topologies.

EXAMPLE 1:

Following is a sample topology configuration for a non-redundant topology using an external switch, that is, a single SCE 2000 connected in receive-only connection mode, to one or two FE links

Would you like to enter the Topology configuration menu? [no]: y

Would you like to enter the Topology configuration menu? [no]: y Enter Connection mode:

1- inline

2- receive-only

Enter your choice [1]: 2

Is this a cascade deployment? [no]: no

Enter admin status of the SCE after abnormal boot:

1- Operational

2- Not-Operational

Enter your choice [1]: 1

Data collection for the system configuration is completed.

All other parameter values are automatically assigned by the system.

Cisco SCE 2000 4/8xFE Installation and Configuration Guide

OL-7826-05 5-21