Cisco Systems SCE 2000 4/8xFE manual SCE 2000 ?

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

	Initial System Configuration
Parameter	Definition
enterprise traps status	Sets the status of the enterprise traps.
system administrator	Name of the system administrator.
Topology Configuration
connection mode	Is the SCE 2000 installed using inline topology or receive-only topology
	using an external switch?
type of deployment	Is this a cascade topology, with two SCE 2000s connected via the cascade
	ports? Or is this a single platform topology?
physically connected link	In a cascade deployment this parameter sets the index for the link that this
(cascade topology only)	SCE 2000 is deployed on. The options for SCE 2000 are link-0 or link-1.
	In a single-SCE 2000 Platform deployment this parameter is not relevant
	since one SCE 2000 is deployed on both links. In this case the link
	connected to port1-port2 is by default link-0 and the link connected to
	port3-port4 is be default link-1.
priority	If this is a cascaded topology, is this SCE 2000 the primary or secondary
(cascade topology only)	SCE 2000?
on-failure behavior	If this SCE 2000 is deployed inline, should the failure behavior be bypass
(inline connection mode	or cutoff of the link?
only)
Admin status of the SCE	After a reboot due to a failure, should the SCE 2000 remain in a Failure
2000 after abnormal boot	status or move to operational status provided no other problem was
	detected?

Following are some general instructions regarding the setup dialog:

•All default values appear in square brackets [default].

If no value appears in the brackets [], or more than one option appears [yes/no], then this parameter does not have a default value.

•To accept the default value, press Enter.

•If you need more information about any parameter, type ? and press Enter.

A help message will appear describing the expected format of the parameter and any other requirements.

•To jump to the end of the setup dialog at any point, accepting all remaining default values, press ^z.

•In certain cases, there will be two or more logically related parameters within a menu. In these situations, it is not permitted to jump to the end of the setup dialog until all related parameters are configured. If you try to jump to the end of the setup dialog, the following message will

appear: “Sorry, Skipping is not allowed at this stage.”

•Certain groups of related parameters, such as time, date, and SNTP settings, form sub-dialogs or menus within the setup dialog. You may skip an entire menu, thereby accepting all default values for the parameters within the menu.

Cisco SCE 2000 4/8xFE Installation and Configuration Guide

OL-7826-05 5-5