
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Connecting the Local Console
Setting Up the Local Console
This section provides instructions for setting up your local terminal at your workstation, to enable you to perform the initial system configuration of the SCE 2000 system using the setup utility.
Figure 5-1: Connecting to the Local Console
Make sure that the terminal configuration is as follows:
•9600 baud
•8 data bits
•No Parity
•1 stop bits
•No flow control
The above SCE 2000 port parameters are fixed and are not configurable.
To set up the local console, complete the following steps:
Step 1 Plug the
Make sure that you push on the
Step 2 Connect the other end of the serial cable (with an attached
Step 3 Make sure the local terminal is configured as a
Step 4 Press Enter several times until the Cisco logo appears on the local terminal and the setup configuration dialog is entered.
At any point you may enter a question mark ‘?’ followed by ‘Enter’ for help. Use
Use
Would you like to continue with the System Configuration Dialog? [yes/no]: y
Step 5 Type y and press Enter.
The system configuration dialog begins.
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
| ||
|
|
|