Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Step 10: Completing and Saving the Configuration
When you have completed the entire configuration, the system checks for errors. If errors are found, a warning message appears. When the configuration is
To complete and save the configuration, complete the following steps:
Step 1 The system informs you that data collection is complete.
We recommend that you view the entire new configuration before it is applied.
Type y and press Enter.
Note that there is no default.
If there are no errors, go to step 3.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]: y
Step 2 If any errors are detected, you may choose to view them.
Press Enter.
Found errors in the new configuration, would you like to view them? [yes]: The following errors were found:
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP
Step 3 You are asked whether to apply and save the configuration.
Apply and Save this configuration? [yes/no]:
•To apply and save the configuration, type y and press Enter.
•To abort the setup procedure without applying or saving the configuration (recommended if there are errors), type n and press Enter.
Setup procedure aborted, no configuration changes made.
If the setup is aborted, the dialog is ended.
Step 4 If there are no errors, the system requests confirmation of either a yes or no answer, in order to prevent mistakes.
Type the appropriate answer (y or n) and press Enter.
The running configuration would be overwritten by the changes you have just entered, are you sure? [yes/no]:
The selected action is carried out by the system.
•If the apply and save action is not confirmed (no), the setup is aborted.
Setup procedure aborted, no configuration changes made.
•If the apply and save action is confirmed (yes), the configuration is applied and saved.
The new running configuration will be saved to the startup configuration.
Step 5 If the configuration was applied and saved, you may also save it to a file at a remote station.
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
| ||
|
|
|
