Cisco Systems SCE 2000 4/8xFE manual ConfiguringAccess Control Lists ACLs

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

Initial System Configuration

Would you like to enter the RDR-formatter configuration menu? [no]: y

Type y and press Enter.

The RDR-formatter destination dialog begins.

Step 2 Type the IP address of the RDR-formatter destination and press Enter.

Enter RDR-formatter destination’s IP address:

Note that there is no default for this parameter.

Step 3 Type the TCP port number of the RDR-formatter destination and press Enter.

Note that there is no default for this parameter.

Enter RDR-formatter destination’s TCP port number:

EXAMPLE:

Following is a sample RDR-formatter configuration dialog, assigning the IP address and TCP port number.

Would you like to enter the RDR-formatter configuration menu? [no]: y

Enter RDR-formatter destination’s IP address: 10.1.1.230

Enter RDR-formatter destination’s TCP port number: 33000

Step 7: ConfiguringAccess Control Lists (ACLs)

The SCE 2000 can be configured with Access Control Lists (ACLs), which are used to permit or deny incoming connections on any of the management interfaces.

Note ACL #0 is a pre-defined list that permits access to all IP addresses.

Configuration of access control lists is done in two stages:

Step 1 Create the access control lists.

You may create 99 ACLs with a maximum of 20 entries per list. Each entry consists of an IP address, and an indication of whether access is permitted or denied to this IP address.

Step 2 Assign the ACLs to the appropriate management interface. (See Step 9: Configuring the Topology-Dependent Parameters (on page 5-19).)

The dialog permits you to skip the creation/editing of the ACLs and go directly to assigning ACLs to the management interfaces.

Cisco SCE 2000 4/8xFE Installation and Configuration Guide

5-12 OL-7826-05