
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
•To disable DNS lookup, type n and press Enter.
Enable IP
If you choose to disable DNS lookup, skip the rest of this section and go to Step 6: Configuring the RDR Formatter Destination (on page
Step 3 Type the default domain name to be used, and press Enter. Note that there is no default domain name.
You may accept the default domain name or enter a new one.
Enter default domain name []:
Step 4 Type the IP address of the primary domain name server and press Enter.
Enter Primary DNS IP address:
Note that there is no default for this parameter.
Step 5 You may configure up to three domain servers.
Would you like to add another Name Server? [no]:
•To exit the DNS settings dialog, press Enter.
•To add another domain server, type y and press Enter.
You are asked to enter the IP address of the next domain name server.
Enter Secondary DNS IP address:
Step 6 When IP addresses for all servers have been entered, exit the dialog by pressing Enter.
Would you like to add another Name Server? [no]:
EXAMPLE:
Following is a sample DNS configuration dialog. The default domain name is pcube.com, and the IP address of the Domain Name Server is 10.1.1.230.
Would you like to enter the DNS configuration menu? [no]: y
Enable IP
Enter default domain name []: pcube.com
Enter Primary DNS IP address: 10.1.1.230
Would you like to add another Name Server? [no]:
Step 6: Configuring the RDR Formatter Destination
The SCE 2000 passes Raw Data Records (RDRs) to an external collection system via the RDR- Formatter. In order for the data to reach the correct location, the IP address of the external collection system and its port number must be configured.
To configure the
Step 1 Enter the RDR formatter configuration menu.
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
| ||
|
|
|