Chapter 5 Installing Software on the CiscoWorks 1105 and 1130 WLSE

Upgrade Methods

Upgrading from the Recovery CD

If you have a recovery CD with the release of the WLSE software you want to install, you can use the CD to upgrade your WLSE.

Note Although every effort has been made to validate the accuracy of the software version on the recovery CD, you must review WLSE software versions on Cisco.com and download and install any required earlier updates. For information on installing such updates, see the readme files that accompany software updates on Cisco.com.

Caution This procedure will destroy all data and install a new image. You will need to replace the data by restoring a backup. For information on backups, see the online help or the User Guide for the Wireless LAN Solution Engine, Release 2.5.

To reimage the WLSE, use the following procedure.

Procedure

Step 1 Connect a console to the WLSE’s console port.

For the WLSE 1105, use the serial port on the front panel; do not use the serial port on the back panel as a console port.

For the WLSE 1130, the serial/console port is on the back panel.

Step 2 Log in as the admin user.

Step 3 Put the recovery CD in the CD drive.

Step 4 Enter the following command; the WLSE will reboot.

reload

Step 5 At the following prompt, enter yes:

Caution If you decide not to reimage the WLSE, enter rescue. For more information about the rescue image, see the User Guide for the Wireless LAN Solution Engine, Release 2.5.

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

5-12

78-15903-01

Page 112
Image 112
Cisco Systems SOFTWARE RELEASE 2.5 warranty Upgrading from the Recovery CD, At the following prompt, enter yes