Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE

Setting Up Device Management

Step 5 To enable and configure Telnet:

a.Select SERVICES > Telnet/SSH.

b.Enable Telnet.

c.(Optional) Enable Teletype.

d.Enter the number of Columns.

e.Enter the number of Lines

f.Click Apply.

Step 6 Select SNMP from the menu.

a.After Simple Network Management Protocol (SNMP), select Enabled.

b.Click Apply.

Step 7 In the SNMP Request Communities section, enter a community string for the ISO view:

Note This community string is required for the access point to be discovered and managed by the WLSE. Devices that do not have an ISO view will be placed in the Misconfigured Devices group after discovery, and faults will be generated. The fault messages refer to a “dot 11 MIB” problem.

a.Enter the community string in the SNMP Community field.

b.Enter iso in the Object Identifier (optional) field.

c.Click Read-Only.

d.Click Apply.

Step 8 In the SNMP Request Communities section, enter a read/write community string.

Note This community string is required to enable firmware updates and configuration downloads on the access point.

a.Enter the community string in the SNMP Community field.

b.Click Read-Write.

c.Click Apply.

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

4-20

78-15903-01

Page 82
Image 82
Cisco Systems SOFTWARE RELEASE 2.5 warranty Select Services Telnet/SSH, Click Read-Only, Click Read-Write