Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE

Setting Up Device Management

Log in to each device’s Web interface. See Set Up IOS Access Points by Using the Web Interface, page 4-19.

After you set up a device, all of the MIB variables can be accessed and the device can be discovered by the WLSE.

About Configuration for VLANs

VLAN information for IOS access points might not be collected by the WLSE if the WEP keys are not configured in each VLAN. This affects VLAN reports, device grouping, and faults for IOS access points. VLAN information becomes accessible as soon as WEP keys are configured.

About Configuration for WDS

If you are using Wireless Domain Service (WDS), you must configure one or more access points to provide WDS. Currently, WDS is supported on Cisco Aironet 1100 and 1200 access points. For information on configuring access points and the WLSE for WDS, see Enter WLCCP Credentials for Wireless Domain Services (WDS), page 4-27.

Set Up IOS Access Points by Using the Device CLI

Step 1 Use Telnet or SSH (secure shell protocol) to log into the AP 1100 or AP 1210.

Step 2 Enter enable mode.

Step 3 Enter global configuration mode.

Step 4 To use Cisco Discovery Protocol (CDP) for discovery, enable CDP by entering the following command:

cdp run

Note To find out whether CDP is enabled, use the show cdp command in enable mode.

Note For information on alternatives to using CDP for discovery, see

Discovering Devices, page 4-30.

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

78-15903-01

4-17

Page 79
Image 79
Cisco Systems SOFTWARE RELEASE 2.5 warranty About Configuration for VLANs, About Configuration for WDS