Cisco Systems SOFTWARE RELEASE 2.5 warranty Set Up IOS Access Points by Using the Web Interface

Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE

Setting Up Device Management

The following optional commands are recommended:

width 80

length 24

Step 9 Exit global configuration mode, then enter the following command:

write memory

Set Up IOS Access Points by Using the Web Interface

Step 1 Log into the Web interface of the AP 1100 or AP 1210.

Step 2 Select SERVICES from the menu, then click CDP:

a.After Cisco Discovery Protocol (CDP), select Enabled.

b.Click Apply.

Note If you do not want to use CDP for discovery, see Discovering Devices, page 4-30, for alternative methods.

Step 3 To push configuration templates to IOS access points, you can use either Telnet or SSH (secure shell protocol). You must configure either Telnet or SSH; you can configure both. See Steps 4 and 5 for procedures.

Step 4 To enable and configure SSH (secure shell protocol), enter the following:

a.Select SERVICES > Telnet/SSH.

b.Enable Secure Shell.

c.Enter a System Name.

d.Enter a Domain Name (for example, cisco.com).

e.(Optional) Enter the RSA key size

f.(Optional) Enter the Authentication Timeout.

g.(Optional) Enter Authentication Retries.

h.Click Apply.

	Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-15903-01	4-19