Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE

Setting Up Device Management

Table 4-7 Set Up Procedures for Routers and Switches (continued)

Task

Procedure

Notes

 

 

 

3. (Optional) Set

On IOS-based devices, enter configuration mode and

These variables make the

the system name,

use the following commands:

device more manageable.

contact, and

Set system name—hostnamename.

The system name, system

location

Set system contact—snmp contact contact.

contact, and location will

variables.

appear in the device detail

 

Set location—snmp location location.

 

displays.

 

On Hybrid OS-based Catalyst switches, enter enable

 

 

mode and use the following commands:

 

 

Set system name—set system name name.

 

 

Set system contact—set system contact contact.

 

 

Set location—set system location location.

 

 

 

 

Set Up AAA Servers

The WLSE can monitor the performance of AAA (Authentication, Authorization, and Accounting) services provided by:

CiscoSecure ACS Server.

Cisco Access Registrar (CAR) (RADIUS services only).

The WLSE supports LEAP, RADIUS, EAP-MD5, and PEAP servers. For information on supported versions of CiscoSecure ACS, see the Supported Devices Table for WLSE 2.5 on Cisco.com.

An AAA server is required for using Wireless Domain Service (WDS). For more information about configuring for WDS, see Enter WLCCP Credentials for Wireless Domain Services (WDS), page 4-27.

Note For PEAP, in addition to the procedures in this section, you must also do the following on the ACS server: set up a certificate and private key and enable PEAP. For more information, see the Cisco Secure ACS documentation.

Step 1 Log into the CiscoSecure ACS Server that will provide authentication services to the wireless network.

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

4-22

78-15903-01

Page 84
Image 84
Cisco Systems SOFTWARE RELEASE 2.5 warranty Set Up AAA Servers, Set location-set system location location