Cisco Systems SOFTWARE RELEASE 2.5 warranty Ip ssh time-out Ip ssh authentication-retries

Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE

Setting Up Device Management

Step 5 To set up SNMP community strings, enter the following commands in the sequence shown.

•The first two commands create an ISO view and set the read-only community string for discovery, faults, and reports. IOS access points that do not have an ISO view will be placed in the Misconfigured Devices group after discovery and faults will be generated. The fault messages refer to a “dot11 MIB” problem.

•The third command sets a read/write community string for updating access point firmware and configuring access points.

snmp-server view iso iso included

snmp-server community community_string view iso RO snmp-server community community_string RW

Note These community strings must also be entered on the WLSE before the device can be discovered and managed. See Enter SNMP Community Strings for All Managed Devices, page 4-25.

Step 6 To push configuration templates to IOS access points, you can use either Telnet or SSH. You must configure either Telnet or SSH or both. See Steps 7 and 8 for procedures.

Step 7 To enable and configure SSH, enter the following commands. After the prompt for the number of bits in the modules, press Return to accept the default or enter a value.

hostname hostname

ip domain-name domain_name

crypto key generate rsa

How many bits in the modulus [512]:

In the preceding commands, hostname is the hostname of the access point, and domain_name is your domain name (for example, cisco.com).

The following commands are optional, but are recommended:

ip ssh time-out 120

ip ssh authentication-retries 3

Step 8 To configure Telnet, enter the following commands. Telnet is enabled by default.

line 0 4

no access-class 111 in

	Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
4-18	78-15903-01