Chapter 4 Configuring the CiscoWorks 1105 and 1130 WLSE
Configuring the WLSE’s Network Information
Step 3 At the login prompt, enter setup.
When you boot the system for the first time, it is not configured. Logging in as setup allows you to configure the system.
Step 4 Enter responses to the first set of prompts to configure the WLSE’s connectivity. Table
Table
Prompt | Response Description | Sample Response |
|
|
|
host name: | System host name. | SolutionEngine |
|
|
|
domain name: | System domain name. | cisco.com |
|
|
|
<username> password: | Sets the password for the default user admin. | wq1Cvu2pl |
|
|
|
confirm password: | Characters you type do not appear on screen. | wq1Cvu2pl |
| Note Default user admin is reserved and cannot |
|
| be deleted or changed. |
|
| You can use the admin password to log into the |
|
| Web interface and to use CLI commands. |
|
|
|
|
eth0 IP address: | IP address of Ethernet 0 interface.1 | 209.165.200.224 |
eth0 network mask: | Network mask of Ethernet 0 interface. | 255.255.255.224 |
|
|
|
default gateway IP address: | IP address of default router that connects WLSE to | 209.165.200.224 |
| network. |
|
|
|
|
DNS server IP address: | IP address of DNS server that WLSE uses for | 209.165.201.1 |
| name/address resolution.The setup program does |
|
| not validate the IP address you enter. |
|
| If you are not using a DNS server, see the |
|
| Configuring the WLSE Without a DNS Server, |
|
| page |
|
|
|
|
Would you like to save this | • Type yes to save the configuration. The |
|
configuration? [yes]: | configuration is saved and system reboots. |
|
| • Type no to exit without saving configuration |
|
| and run setup program again. |
|
|
|
|
1. Corresponds to the Ethernet port labeled "A" on the WLSE 1130.
| Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine |
|
