Cisco Systems UBR-3X10 Scope, Document Organization, Document Conventions, “Cisco uBR-3x10 RF

Preface

Scope

Tip Statement numbers (Statement 1030) at the end of a warning refer to specific warnings and their translations found in the Regulatory Compliance and Safety Information for the Cisco RF Switch.

Scope

The guide provides installation and cabling information for the Cisco uBR 3x10 RF Switch. Refer to the “Related Documentation” section on page 10 for related Cisco publications that provide configuration information for the Cisco uBR 3x10 RF Switch.

Document Organization

This hardware installation guide is organized into the following chapters and appendixes:

Chapter Title	Description
Chapter 1, “Cisco uBR-3x10 RF	Describes the Cisco uBR 3x10 RF Switch chassis and
Switch Overview”	components, illustrating the supported system configurations.
Chapter 2, “Preparing for	Describes safety considerations, tools, and other equipment
Installation”	required to prepare your site.
Chapter 3, “Installing the	Provides instructions to install and connect cables to the chassis.
Cisco RF Switch”
Chapter 4, “Cabling the RF Switch	Provides instructions for connecting Cisco uBR 3x10 RF Switch
With the Cisco uBR10012 CMTS	cable network redundancy cables in a Cisco uBR10012 CMTS
Cable Interface Line Cards”	environment.
Chapter 6, “Troubleshooting”	Provides basic Cisco uBR 3x10 RF Switch troubleshooting
	information.
Appendix A, “Specifications and	Provides Cisco uBR 3x10 RF Switch system specifications.
Component Part Numbers”

Document Conventions

This guide uses the following conventions:

Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in this manual.

Caution Means reader be careful. You are capable of doing something that might result in equipment damage or loss of data.

Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide

4 OL-1984-06