Cisco Systems UBR-3X10 manual Following section describes cabling the RF switch for output

Chapter 5 Cabling the RF Switch With the Cisco uBR7246VXR CMTS

Connecting the Cables (Cisco uBR-MC28x Line Card)

Cabling the Output Cables (CABLE PLANT to HUB)

The following section describes cabling the RF switch for output.

Note The output cables (CABLE PLANT) on the RF Switch are cabled in the reverse order of the input cables (CMTS).

Equipment

•16 cable bundles (MCX connector to F-connector—multicolor)

•16 header blocks (installed)

Note Two more cable bundles may be required if you intend to route the upstream cables and the downstream cables to different locations.

To cable the output to the cable plant, complete the following steps.

Step 1 Install the output cables in the header blocks. Start with the header block on the far right (1H—1A). For easier troubleshooting, use the same color sequence that was used for CMTS cabling.

A–red, B–white, C–blue, D–green. H–yellow, I–violet, J–orange, K–black.

Step 2 Run the output cables (H–A) from header blocks to splitters, US laser receivers, or the low side of the diplex filters

Step 3 Run the output cables (M–F) to the splitters and combiners, DS laser transmitters, or the high side of the diplex filters.

Figure 5-17 RF Switch Cable Plant Outputs (Turquoise)

			RFS-2
	P2A-P2H		RFS-1
P1A-P1H
2A-2H 4A-4H 6A-6H 8A-8H		7H-7A 5H-5A 3H-3A 1H-1A
1A-1H 3A-3H 5A-5H 7A-7H		8H-8A 6H-6A 4H-4A 2H-2A
			103930
Working CMTS	Protect

Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide

OL-1984-06 5-25