STATUS INDICATORS
Be sure to use only genuine SHARP parts and supplies.
When the following indicators light up or blink on the operation panel or the following symbols appear in the display, solve the problem immediately referring to both the table below and the relevant page.
| Indication |
| Cause and remedy | ||
|
|
|
|
|
|
| Drum replacement |
| Steadily | Replacement of drum cartridge will be needed soon. Prepare a | |
w | required indicator |
| lit | new cartridge. p. | |
|
|
|
|
| |
|
| Blinking | Drum cartridge must be replaced. Replace it with a new one. | ||
|
|
|
| ||
|
|
|
|
| p. |
|
|
|
|
| |
| TD cartridge replace- |
| Steadily | Replacement of TD cartridge will be needed soon. Prepare a new | |
s | ment required indicator |
| lit | cartridge. p. | |
| Blinking | TD cartridge must be replaced. Replace it with a new one. | |||
|
|
|
| ||
|
|
|
|
| p. |
|
|
|
|
| |
t | Misfeed indicator |
| Blinking | A misfeed has occurred. Remove the misfed paper referring to | |
|
|
|
|
| the description of „Misfeed removal.“p. |
|
|
|
|
| area is not raised. p. |
|
| Blinking | An original misfeed has occurred in the SPF orin the | ||
| indicator |
|
| Remove the misfed originals referring to the description of "Mis- | |
|
|
|
|
| feed in the SPF or in the |
| The paper tray indicator |
| The paper tray is not installed properly. Push the tray into the | ||
| is blinking. |
| copier securely. | ||
|
|
|
| ||
| „CH“is blinking in |
| The TD cartridge is not installed. Check if the cartridge is instal- | ||
n | the display. |
| led. p. | ||
„CH“is steadily lit in the |
| Side cover is open. Close the side cover securely by pressing the | |||
|
| ||||
| display. |
| round projections near the side cover open button. p. | ||
|
|
|
| ||
| „P“is blinking in |
| Paper tray or bypass tray is empty. Load copy paper. p. | ||
| the display. |
|
| ||
Q |
|
|
|
| A misfeed has occurred in the paper tray or bypass tray. Remo- |
|
| ve the misfed paper. p. | |||
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| Paper tray is not securely installed. Push the tray in securely. |
|
|
|
|
| p. |
| A letter and a number |
| The copier will not function. Turn the power switch off and then | ||
| appear alternately. |
| switch it on,and if there is again an error, remove the power cord | ||
|
|
|
|
| from the outlet, and contact your authorized Service representative. |
|
|
|
|
|
|
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
1.Press the clear (>) key to reset the display to zero.
2.Press and hold down the clear (>) key for approximately 5 seconds. The total number of copies will appear in two steps, each with three digits.
Example:
Total number of copies is 1,234.
G B
