Unicode and Fonts
100-88002 Rev B Page 195
The Epic 880TM always prints at 203 dots per inch (dpi) and always uses the scalable
font to form characters. The resulting characters are not necessarily exactly the dot
size indicated, but are always spaced in a fixed dot cell provided that the legacy
commands are used. Adding or subtracting space between characters achieves
different character pitches with a fixed character cell size. As each dot has a fixed size
and position, only specific pitches are possible. The following table defines the fonts
and pitches possible with each.
Character Cell (H x W) 10x24 Font
(W x H)
13x24 Font
(W x H)
15x24 Font
(W x H)
Horizontal Width 10 Dots
0.0493 inches
13 Dots
0.0640 inches
15 Dots
0.0739 inches
Vertical Height 24 Dots
0.118 Inches
24 Dots
0.118 Inches
24 Dots
0.118 Inches
Character spacing in Characters per Inch (CPI)
Pitch at native cell size 20.30 15.62 13.5
5 dot Removed 40.60 25.38 20.30
4 dot Removed 33.83 22.56 18.45
3 dot Removed 29.00 20.30 16.92
2 dot Removed 25.38 18.45 15.62
1 dot Removed 22.56 16.92 14.50
0 dot added 20.30 15.62 13.53
1 dot added 18.45 14.50 12.69
2 dots added 16.92 13.53 11.94
3 dots added 15.62 12.69 11.28
4 dots added 14.50 11.94 10.68
5 dots added 13.53 11.28 10.15
6 dots added 12.69 10.68 9.67
NOTE: Combinations shown in shaded areas are not recommended.
Table 9. Possible Character Pitches
Character spacing may also be selected by requesting a print pitch based on
characters pre inch. Once again, the results are not exact in this case. The following
table lists the resulting spacing based on a given CPI request.
Requested
CPI Character Width Resulting CPI Requested CPI Character Width Resulting CPI
0 variable variable 16 12 16.92
1 203 1.00 17 12 18.45
2 101 2.01 18 11 18.45
3 67 3.03 19 10 20.30
4 50 4.06 20 10 20.30
5 40 5.08 21 9 22.56
6 33 6.15 22 9 22.56
7 29 7.00 23 8 25.38
8 25 8.12 24 8 25.38
9 22 9.23 25 8 25.38
10 20 10.15 26 7 29.00
11 18 11.28 27 7 29.00
12 16 12.69 28 7 29.00
13 15 13.53 29 7 29.00