Epson 100-88002 manual 1BH 2BH 4AH

Unicode and Fonts

If d = 0 variable spacing is selected.

Note: If the current character size is too large for the selected spacing, the characters will overlap. Variable spacing is recommended.

Function	Set Character spacing in ¼ points.		All
ASCII	[ESC] + i <d>
Hexadecimal		1BH 2BH 69H
Decimal	<27> <43> <105>
Range	d	= 0, 16 – 255

The [ESC] + i command will set the character spacing in points, where ¼ point is defined as 1/288th of an inch. This command will force mono-space printing. It will override any character spacing set by the set character height and width commands defined above. This spacing will be enforced until deactivated by setting the value to 0 or if the set character height and width commands use a 0 for the width indicating proportional spacing should be used. This command differs from the [ESC] + j command in that all characters are centered on the fixed cell size. It the character is too big for the cell, it may overlap the previous and next character. The character size is not adjusted to fit the cell.

If d = 0 variable spacing is selected.

Note: If the current character size is too large for the selected spacing, the characters will overlap. Variable spacing is recommended.

Function	Set Character spacing in points with adjustment.		All
ASCII	[ESC] + J <d>
Hexadecimal		1BH 2BH 4AH
Decimal	<27> <43> <74>
Range	d	= 0, 4 – 72

The [ESC] + J command will set the character spacing in points, where one point is defined as 1/72nd of an inch. This command will force mono-space printing. It will override any character spacing set by the set character height and width commands defined above. This spacing will be enforced until deactivated by setting the value to 0 or if the set character height and width commands use a 0 for the width indicating proportional spacing should be used. This command differs from the [ESC] + I command in that if the character is too large for the cell, the cell will be expanded in multiples of <d> until the character fits.

If d = 0 variable spacing is selected. However, note that the cell adjustment flag will remain set and if legacy commands are used they will allow the cell to be expanded.

Note: If the current character size is too large for the selected spacing, the cell size will be expanded

Page 214 100-88002 Rev B