Epson 100-88002 manual Function Print Current Configuration and Totals

Epic 880TM Extended Printer Control

Function Print Current Configuration and Totals

ASCII [ESC] y <9> or [ESC] ~ <9>

Hexadecimal 1BH 79H 09H Decimal <27> <121> <9>

Description This command forces the printer to print the current configuration. To function correctly it must be issued with the printer in the proper emulation mode. It is intended to be printed in the default TransAct® configuration but will print in any configuration.

Note: This command must be preceded with an ESC y <8>.

Function Print Current Totals

ASCII [ESC] y <15>

Hexadecimal 1BH 79H 0FH Decimal <27> <121> <15>

Description This command forces the printer to print the current totals log. Note: This command must be preceded with an ESC y <8>.

Function Print Current Print Setup Values

ASCII [ESC] y <20> or [ESC] ~ <20>

Hexadecimal 1BH 79H 14H Decimal <27> <121> <20>

Description This command forces the printer to print the current setup values. Note: This command must be preceded with an ESC y <8>.

Function: Set Electronic Journal Print Configuration Control

ASCII: [ESC] ~ j <n>

Hex: 1BH 7EH 6AH

Decimal: <27><126><105>

Description This command reconfigures the electronic journal print mode record separator and manual printing modes

Where n = 76543210		Bit values
------X0	Manual Electronic Journal Print mode is Enabled
------X1	Manual Electronic Journal Print mode is Disabled
------0X	A Record separation line is printed that may contain a		record
number.
------1X	No Record separation line is printed.

Note: Both parameters must be set at the same time by this command.

Note: The record separation configuration may be set in manual configuration mode. This command will reset the configuration to the value specified here.

Note: This command performs a configuration update, and should not be done on a regular basis.

Note: This command must be preceded with an ESC y <8> to enable it.

100-88002 Rev B Page 231