Control Codes

[ESC] V

Set inter-character spacing (Legacy Command)

Mode

Global

 

ASCII

[ESC] V <n>

Hexadecimal

1BH 56H <n>

Decimal

<27> <86> <n>

IPCL

none

 

EPOS

[ESC] [SP] <n>

Description The [ESC] V <n> command sets inter-character spacing by adding white space between characters. The value of <n> sets the spacing in 216ths of an inch. The printer can only set the spacing in 208ths of an inch and converts 216ths to the nearest 208th of an inch. Each font has a basic size, and the inter-character spacing value is added to the basic size. Therefore, the affect of this command on characters per inch (cpi) will depend on the font selected.

Note 1: The [ESC] V <n> command disables any pitch settings established by pitch set commands that establish a cpi (like [ESC] [ P <n>). After a set right-side spacing command is issued, the pitch will vary with font selection. Font selections use the current, active, right-side spacing.

Note 2: With the inter-character spacing command, the pitch cannot be set less than the font size. Therefore, it is not as effective as the pitch command, [ESC] [ P <n>. The following table lists the cpi equivalent for several values of <n>.

The following table lists the cpi equivalent for several values of <n>.

<n>

Small Draft (cpi)

Large Draft (cpi)

NLQ (cpi)

0

17.33

14.86

13

1

16

13.9

12.24

2

14.86

13

11.6

3

13.9

12.24

10.9

4

13

11.6

10.4

5

12.24

10.9

9.90

Table 4 Inter-character Spacing

Page 92

100-88002 Rev B

 

 

Page 104
Image 104
Epson 100-88002 manual Esc, Set inter-character spacing Legacy Command, Mode Global, ESC V n