Epson 100-88002 manual Vertical Motion Control

Control Codes

Vertical Motion Control

[ESC] j Perform a fine line feed

ASCII [ESC] J <n>

Hexadecimal 1BH 4AH <n>

Decimal <27> <74> <n>

IPCL &%FM <m1> <m2> <m3>

EPOS [ESC] J <n>

Description The [ESC] J <n> command prints the contents of the buffer and performs a line feed of n/216 inch. The default line spacing value is not changed. The next character print position is reset to the left margin if the Auto-CR mode is set.

Notes:

•In EPOS mode, the command performs feeds in n/144-inch increments.

•Immediately after APA graphics, the command is adjusted for the difference between 72 dpi graphics and 96 dpi print.

[ESC] 3 Set variable line spacing to n/216 inch

ASCII [ESC] 3 <n>

Hexadecimal 1BH 33H <n>

Decimal <27> <51> <n>

IPCL &%SV <m1> <m2> <m3>

EPOS [ESC] 3 <n>

Description The [ESC] 3 <n> command sets the default line spacing to n/216 inch, where n = 1 to 255. The line feed spacing used by [LF] is set to values other than 1/8 or 7/72 inch. The command takes effect immediately.

Note: In EPOS mode, the command performs line feeds in n/144-inch increments.

[ESC] 0	Set line spacing to 1/8 inch
ASCII	[ESC] 0
Hexadecimal		1BH 30H
Decimal	<27> <48>
IPCL	&%ST
EPOS	[ESC] 2

Description The [ESC] 0 command sets the default line spacing to 1/8 inch (27/216 inch), which is the standard eight lines per inch line spacing at initial power-up.

Note: In EPOS mode, the command sets 1/6-inch spacing or six lines per inch.

100-88002 Rev B Page 79