Epson 100-88002 manual Initial entry

Control Codes

Receipt or
Inserted Form	Initial entry
	location
A > > > > >
D > > > > >
B> > > > >
> > > > > C

Note 1: This command saves the current right and left margin and sets them to the maximum values for the orientation currently defined.

Note 2: During page mode definition almost all printer commands are active. The following table lists the exceptions.

Command	Active	Action
Cash drawer	Yes	Immediate action
commands
Bell command	Yes	Immediate action
Auto cut	Delay	The printer will perform a feed to cut and then operate the auto
commands	ed	cutter after the page is printed. The cut command may be
		anywhere in the definition. If the page is printed twice, the Auto
		cut command must be reissued after the first print to generate
		additional cuts.
Electronic journal	No	This command is like a station select and is not active. You
station select		cannot store page mode images in the electronic journal. A
		page mode command in journal station mode will exit journal
		mode.
Electronic journal	Yes	You can make journal entries as part of a page description.
entries		They are saved as text and not part of the page.
Status requests	Yes	The status is returned during definition.
Printer initialize	Yes	Cancels page mode definition and returns the printer to
command		standard mode.
Set top of form	No	You must set the top of form outside of page mode. The form
		position is maintained after the page is printed.
Vertical tab	No	The definition of a vertical tab is ambiguous in page mode and
		is ignored.
Macro definitions	No	You can not define or delete a macro while in page mode. You
		can, however, invoke a macro or stored graphic. You can not
		enter page mode while in a macro definition.

Note 3: Unless specified by a page mode set page size command, the default page size is the full paper width for about 14 inches. Printing starts at the current paper

Page 108 100-88002 Rev B