Control Codes
The terminating <0> may be replaced with an & or redefined. See [ESC] [EM]T<n> or &%UT<n> on page 128.
Note: The report is also printed as part of the configuration report.
Function | Redefine User Store Termination Character | |
ASCII | [ESC] [EM] T <n> | |
Hexadecimal | 1BH 19H 54H <n> | |
Decimal | <27> <25> <84> <n> | |
IPCL | &%UT <n> | |
EPOS | None |
|
Description This command allows the terminator used to signal the end of the name field in User Store commands to be modified. The value of <n> is used (in addition to the <0>) for the terminator. The value of n may be from 0 to 255.
The default value for the second terminator is &. If this command redefines the terminator to something other than &, the & will no longer function.
Example If &%UT% were sent to the printer, the user store command to run macro “Demo” would be &%URDemo%.
Page 128 |
|
|
|
